HX-Injection Medium™ - Red /3,62 kg

HX-Injection Medium™ is a low viscosity latex used for medical and veterinarian training. Available in blue or red, latex is injected into cadaver blood vessels to make arteries and veins visible, aiding in identification during the dissection process. Red injection medium is commonly used to highlight arteries, Blue injection medium is commonly used to highlight veins

PROCESSING RECOMMENDATIONS

SAFETY FIRST Keep Out of Reach of Children

BE CAREFUL - Avoid use if you have known allergies to natural latex. Avoid contact with eyes. Flush eyes with water for 15 minutes and seek medical attention. Remove from skin with waterless hand cleaner followed by soap and water. Children should not use thisproduct without adult supervision.

GENERAL PREPARATION:

Do not allow HX-Injection Medium to freeze. The material will not be usable. Store and use material at room temperature 23°C. This product has a limited shelf life and should be used as soon as possible. Colder temperatures will slow the working/ cure time, while warmer temperatures will reduce working time. Wear safety glasses, long sleeves and rubber gloves to minimize contamination risk. Wash thoroughly after handling. Do not eat, drink or smoke in the work area. Keep container closed when not in use.

POURING, USING & PERFORMANCE:

MIXING AND USING:

Stir before use. Approximately 1 liter of injection medium is sufficient for an adult cadaver. Injection of the HX-Injection Medium™ should be performed 2 weeks after the embalming process. A syringe can be used to inject smaller isolated areas while a pressure pump (~1 Kpa) can be used to inject into larger areas. Depending on the volume, and area injecting the HX-Injection Medium™ into, it can take up to a week for the latex
to fully solidify, while smaller areas can be ready in 1-2 days.

CLEAN UP:

Clean up wet and dry latex with soap and water.